If you try to lower Super Duty with springs you get trouble, if you heat or cut your springs, even if you use a “lowering” spring you cause alignment issues you just can’t correct out! The fabricated “I-beam” type parts suffer from “weld creep” as they are welded, which simply means they warp a little. That makes it hard to get consistent finished parts! You only need to remove the factory beams and replace with DreamBeams and you have a 3″ drop with the factory coils, full suspension travel and all the goodness that comes with that. The rear end is done with a tried and true Hanger/Shackle kit. This moves the mounting points of the leaf springs up on the frame providing the lowering needed to match the front! A bolt on 3/5 kit for your SuperDuty, simple installation is a DJM trait. Shocks are NOT included Reviews There are no reviews yet. Be the first to review “1987 1998 Ford F-350/250 3 Inch Front 4 Inch Rear Complete Lowering Kit” Cancel replyYour email address will not be published. Required fields are marked *Your rating * Rate… Perfect Good Average Not that bad Very poor Your review *Name * Email * Save my name, email, and website in this browser for the next time I comment.